Tree Roots in Sewer Pipes: An Adelaide Homeowner's Guide
Tree roots in sewer pipes are one of the most common reasons Adelaide homes end up with a blocked sewer, and the problem tends to show up when you least want it: a toilet that won't flush on Christmas Day or a gully overflowing in the backyard. At Northway Plumbing, Aircon & Electrical, our family has been clearing roots from Adelaide sewer lines since 1946, and we see the same pattern every year. According to SA Water, tree roots are the leading cause of sewer blockages across its network in South Australia, and leafy, older suburbs and the foothills see more of them.
With a hot, dry summer ahead, roots go looking for water, and a cracked sewer pipe is an easy target. This guide explains how tree roots get into sewer pipes in Adelaide, the warning signs to watch for, how we find and clear them, when pipe relining makes sense, and what you can do to keep roots out for good.
Direct answer: Tree roots get into sewer pipes in Adelaide through cracked or shifted joints, mostly in older clay pipes, where they find moisture and nutrients. A licensed plumber locates the root intrusion with a CCTV drain inspection, clears it with hydro jetting or root cutting, then repairs the damaged pipe with pipe relining or a dig and replace so roots can't get back in.
How Tree Roots Get Into Sewer Pipes in Adelaide
Tree roots get into sewer pipes through small cracks and loose joints, drawn by the moisture, warmth and nutrients leaking from the pipe. Roots don't punch through solid pipe. Instead, fine feeder roots find the tiniest gap, grow inside, then thicken into a mat that catches toilet paper and debris until the line eventually blocks. Left alone, tree root invasion can crack plumbing pipes further and spread potential damage to the rest of your plumbing systems.
Adelaide has a few local conditions that make root invasion more likely:
- Old vitrified clay pipes. Many homes built before the 1980s, including plenty in Colonel Light Gardens, Unley and Mitcham, still have clay pipes laid in short lengths. Every joint is a potential entry point once the mortar or rubber seal ages.
- Reactive clay soils. Much of Adelaide sits on reactive clay that shrinks in dry summers and swells when wet. That seasonal movement shifts underground pipes and opens joints, which is a point the SA Environment Minister has also raised when explaining burst water mains.
- Dry, hot summers. SA Water reported that Adelaide's summer of 2025-26 had the highest water use since 2003-04, around Adelaide's warmest night on record. When the ground dries out, established trees push their root system further in search of moisture, and a leaking sewer line is a reliable source.
- Big, thirsty trees close to the drain. Gums, figs, jacarandas, willows and many fruit trees have aggressive roots. A tree planted to provide shade 30 years ago may now sit right over the sewer.
Warning Signs of Tree Roots in Your Sewer Lines
The most common sign of tree roots in your sewer lines is drains that run slowly across the whole house, not just one fixture. At Northway Plumbing, Aircon & Electrical we ask Adelaide homeowners to look out for:
- Slow drains in showers, basins and the kitchen sink at the same time
- Gurgling from toilets or floor wastes when water drains elsewhere
- An overflowing gully or overflow relief gully (ORG) outside, the grated fitting designed to spill outside rather than inside your home when the sewer backs up
- Sewage smells in the yard or bathrooms
- Lush, extra green patches of lawn along the line of the sewer, a clear indication that nutrients are leaking into the ground
- Toilets that need a plunger regularly or blockages that return a few weeks after clearing
- Sunken ground or cracked paving over the pipe, which can mean broken pipes and soil washing away
If your ORG is overflowing or sewage is coming up inside, treat it as an emergency. Stop using water and call our 24/7 emergency plumber team.
Finding the Problem With a CCTV Drain Inspection
A CCTV drain inspection is the most accurate way to confirm tree roots in sewer pipes, because it shows exactly where the roots are, how much of the pipe they fill and whether the pipe is cracked or collapsed. Northway feeds a waterproof camera on a flexible rod into the sewer through an access point such as an inspection opening or the gully, and we watch the live footage as it travels the line.
Modern CCTV equipment usually includes a locator, so the exact spot and depth of the problem can be marked from above ground. That can mean the difference between digging one small hole and digging up half the yard, and the footage is handy if you're dealing with an insurer, a neighbour or SA Water.
We recommend a CCTV drain inspection whenever a blockage keeps coming back, before buying an older home with established trees, and after roots are cleared, to check the condition of the pipe.
How We Remove Tree Roots From Sewer Pipes
The fastest way to remove tree roots from sewer pipes is to cut or blast them out with specialised equipment, then deal with the damaged section so they can't regrow. Northway uses two main methods to clear tree roots, often together.
Hydro Jetting With High Pressure Water
Hydro jetting uses high pressure water jetting through a specialised nozzle that cuts through roots, grease and debris and scours the pipe walls clean. It's effective on fine roots and built up sludge, it doesn't rely on harsh chemicals, and it's an environmentally friendly way to restore full flow. Learn more about our hydro jet drain cleaning.
Electric Eel and Root Cutting
An electric eel is a motorised cable with a rotating cutting head. It's useful for punching through a heavy root mass or larger roots that need mechanical cutting before the line can be jetted clean. On many jobs we cut first, then jet, then run the camera to confirm the pipe is clear.
Chemical Treatments, Rock Salt and Copper Sulphate
Chemical treatments and DIY options such as rock salt or copper sulphate are widely sold for root control, but in our experience they have limits. They may slow regrowth of fine roots for a while, but they generally won't clear an established blockage or fix the crack that let the roots in. Some products can also affect the tree, your garden or the wider sewer systems, so always read the label and check whether the product is suitable for sewer use. We see them as a short term measure at best, not a repair.
Clearing roots without fixing the pipe or getting professional assistance usually means the roots come back, often within months, because the cracked joint is still leaking moisture.
Fixing the Damage: Pipe Relining vs Dig and Replace
Once tree roots are cleared, the long term fix is to seal or replace the damaged pipe so roots can't get back in. Northway offers both pipe relining and traditional dig and replace, and the CCTV footage tells us which is the most cost effective option for your property.
Pipe Relining (No Dig)
Pipe relining installs a new pipe inside the old one. A synthetic liner soaked in resin is pulled or inverted into the cleaned pipe and cured in place using composite resin technology, forming a smooth, jointless pipe within a pipe. Because there are no joints, roots have nowhere to enter. It's the latest technology for repairing the damage caused by roots without excavation.
- Little or no digging, so paving, driveways, retaining walls and landscaping stay intact
- Many residential sections can be relined in a day, depending on length and access
- Works well under slabs, mature gardens and hard to access areas
See how our pipe relining in Adelaide works.
Dig and Replace
Sometimes the pipe has collapsed, sagged badly or has the wrong fall, and relining isn't suitable. In that case we excavate and lay a new drain in modern PVC with sealed joints, which resists root intrusion far better than old clay. Dig and replace can also be the better choice when you're already renovating, or when the line needs to re route away from a large tree.
How to Stop Tree Roots Getting Into Your Drain Pipes
The best way to prevent tree roots in sewer pipes is to keep the pipe sealed and keep thirsty trees away from it. Northway suggests a few practical steps for Adelaide homeowners:
- Right tree, right spot. Before planting new trees, check where your sewer runs and choose species with less invasive roots. SA Water's Healthy Pipes tool helps you choose trees that are less likely to damage pipes.
- Root barriers. Physical barriers installed vertically in the ground between a tree and the pipe can redirect roots downward and away. They're most effective when installed early, alongside new landscaping.
- Fix leaks early. A small crack today is a root entry point tomorrow. Relining or repairing a cracked section removes the attraction.
- Don't flush wet wipes. SA Water has reported crews removing around 200 kg of wet wipes from its sewer network in Modbury. Wipes catch on roots and turn a partial restriction into a full blockage. Only flush the three Ps: pee, poo and paper.
If a large tree belongs to a neighbour or sits on the verge, talk to them or your local council before removing or pruning it, as some trees are protected under South Australian regulations.
A Maintenance Schedule for Older Adelaide Homes
For older Adelaide homes with clay pipes and big trees, a regular inspection is the most cost effective way to avoid an emergency. Northway generally suggests:
- Every 1 to 2 years: a CCTV drain inspection if you have established trees near the sewer, clay pipes or a history of blocked drains
- As needed: hydro jetting to keep the line clear of fine roots and debris between repairs
- Before summer: check your ORG is clear and sits below floor level, and keep an eye on slow drains as the soil dries
- Once roots are confirmed: plan a permanent repair such as relining, rather than paying for repeat clears
Every property is different, so this is general advice. Your plumber can tailor the schedule based on your pipe material, tree species and past blockage history.
Who Is Responsible for Tree Roots in the Sewer in South Australia?
Generally, the property owner is responsible for the private sewer drain on their land, up to the point where it connects to SA Water's sewer network. That means repairs to root damaged pipes on your side of the connection usually fall to you, even if the tree belongs to a neighbour. SA Water generally looks after its own sewer mains.
The exact connection point can vary from property to property, so we suggest checking with SA Water if you're unsure where your responsibility ends. If our CCTV inspection shows the blockage is in SA Water's section, we'll tell you so you can contact them directly. For blockages on your side, see our blocked sewer service.
What We Help With: Tree Root Removal Services in Adelaide
Northway Plumbing, Aircon & Electrical handles every stage of tree root problems in Adelaide sewer pipes:
- Tree root removal from sewer pipes and stormwater lines
- CCTV drain inspections to pinpoint the problem
- Hydro jetting and electric eel root cutting
- Pipe relining for cracked, root damaged clay pipes
- Dig and replace pipe repairs with new PVC drain lines
- Blocked sewer and blocked drains clearing, including 24/7 emergency call outs
- ORG checks and advice on plumbing fixtures and drainage issues
Common Questions About Tree Roots in Sewer Pipes
What dissolves tree roots in sewer lines?
Some chemical root treatments and products such as copper sulphate or rock salt are sold to kill or slow tree roots in sewer lines, but in our experience they don't reliably dissolve an established root mass. They may help with fine regrowth, but they won't repair the crack the roots came through. Mechanical cutting and hydro jetting clear the blockage, and relining or pipe repairs stop it coming back.
How can I remove tree roots from my sewer pipes?
The most reliable way to remove tree roots from sewer pipes is to have a professional plumber cut them out with an electric eel or blast them out with high pressure water, then check the pipe with a CCTV camera. Hiring DIY equipment can clear a small blockage, but it risks damaging fragile clay pipes and rarely removes all the roots. Without sealing the damaged pipe, roots will usually grow back.
How do you stop tree roots getting into drains?
You stop tree roots getting into drains by sealing the pipe and managing nearby trees. Pipe relining creates a jointless pipe roots can't enter, while root barriers redirect roots away from the drain. Choosing less invasive species, using SA Water's Healthy Pipes tool before planting, and avoiding wet wipes all reduce the risk. For older clay pipes, a regular CCTV inspection catches root intrusion before it causes a full blockage.
What is a CCTV drain inspection?
A CCTV drain inspection is a camera survey of your underground pipes. A plumber feeds a waterproof camera through an access point and records live footage of the pipe's condition, showing roots, cracks, collapses, sags and blockages. A locator pinpoints the problem's position and depth from above ground. The footage helps you choose the right repair, avoids unnecessary digging and gives you a record for insurers or future buyers.
Is pipe relining worth it?
Pipe relining is usually worth it when tree roots keep returning to a cracked but otherwise intact pipe, especially under paving, driveways or established gardens. It creates a jointless pipe roots can't penetrate, with little or no digging. Relining isn't suitable for every pipe, for example a fully collapsed or badly sagging line, so a CCTV inspection should come first. Cost depends on pipe length, diameter, access and the number of junctions.
Why Choose Northway for Tree Roots in Sewer Pipes
Northway Plumbing, Aircon & Electrical is an Adelaide family plumbing business that has been working on local sewer lines since 1946. Now in its fourth generation and run by Brett and Grant Calladine, we know the clay pipes, reactive soils and big old trees found across Adelaide's suburbs. We use CCTV cameras to diagnose before we quote, explain your options in plain language, and offer 24/7 emergency plumbing when a root blockage can't wait. We're licensed for plumbing, gas fitting and electrical work, so one call covers the job.
Local Tree Root Removal Across Adelaide
From our base in Panorama, we clear tree roots in sewer pipes across southern Adelaide and beyond, including Pasadena, Colonel Light Gardens, Mitcham, Unley, Blackwood and Belair. Leafy suburbs with older homes and mature street trees, and the foothills towards the Adelaide Hills, are where we see the most root intrusion, which matches SA Water's experience that foothill and leafy areas get more sewer blockages. We also work throughout the western and northern suburbs.
Quick Answers
- Leading cause of sewer blockages in SA: tree roots, according to SA Water.
- Most at risk pipes: older vitrified clay pipes with many joints.
- Why Adelaide is prone: reactive clay soils shrink and swell, shifting pipe joints.
- Best way to find roots: a CCTV drain inspection.
- Best way to clear roots: hydro jetting and/or electric eel cutting.
- Best long term fix: pipe relining or replacing the damaged section with PVC.
- Who pays: generally the property owner, up to the connection point. Check with SA Water if unsure.
- Prevention: right tree, right spot, root barriers and no wet wipes.
Tree roots in sewer pipes in Adelaide won't fix themselves, and every summer the roots grow a little further. If you've noticed slow drains, gurgling or an overflowing gully, give Northway Plumbing, Aircon & Electrical a call or get in touch online. We'll find the problem, clear the roots and recommend a fix that keeps them out.
